DISABLE_OVERSCAN = "1" TOTAL_BOARD_MEM = "3072" do_deploy_append_raspberrypi4() { # ENABLE CAN if [ "${ENABLE_CAN}" = "1" ]; then echo "# Enable CAN" >>${DEPLOYDIR}/bootfiles/config.txt echo "dtoverlay=mcp2515-can0,oscillator=16000000,interrupt=25" >>${DEPLOYDIR}/bootfiles/config.txt fi # Handle setup with armstub file if [ -n "${ARMSTUB}" ]; then echo "\n# ARM stub configuration" >> ${DEPLOYDIR}/bootfiles/config.txt echo "armstub=${ARMSTUB}" >> ${DEPLOYDIR}/bootfiles/config.txt case "${ARMSTUB}" in *-gic.bin) echo "enable_gic=1" >> ${DEPLOYDIR}/bootfiles/config.txt ;; esac fi if [ "${AGL_XEN_WANTED}" = "1" ]; then echo "total_mem=${TOTAL_BOARD_MEM}" >> ${DEPLOYDIR}/bootfiles/config.txt fi } do_deploy_append() { if [ "${ENABLE_CMA}" = "1" ] && [ -n "${CMA_LWM}" ]; then sed -i '/#cma_lwm/ c\cma_lwm=${CMA_LWM}' ${DEPLOYDIR}/bootfiles/config.txt fi if [ "${ENABLE_CMA}" = "1" ] && [ -n "${CMA_HWM}" ]; then sed -i '/#cma_hwm/ c\cma_hwm=${CMA_HWM}' ${DEPLOYDIR}/bootfiles/config.txt fi echo "avoid_warnings=2" >> ${DEPLOYDIR}/bootfiles/config.txt echo "mask_gpu_interrupt0=0x400" >> ${DEPLOYDIR}/bootfiles/config.txt echo "dtoverlay=vc4-kms-v3d-overlay,cma-256" >> ${DEPLOYDIR}/bootfiles/config.txt echo "dtoverlay=rpi-ft5406-overlay" >> ${DEPLOYDIR}/bootfiles/config.txt echo "dtparam=audio=on" >> ${DEPLOYDIR}/bootfiles/config.txt } do_deploy_append_raspberrypi4() { echo -e "\n[pi4]" >> ${DEPLOYDIR}/bootfiles/config.txt echo "max_framebuffers=2" >> ${DEPLOYDIR}/bootfiles/config.txt } do_deploy_append_sota() { echo "device_tree_address=0x0c800000" >> ${DEPLOYDIR}/bootfiles/config.txt } ENABLE_UART_raspberrypi3 = "1" ENABLE_UART_raspberrypi4 = "1"