From 0b778b66400f67417672dd1849f5b90daa32d8a6 Mon Sep 17 00:00:00 2001 From: mgiannikouris Date: Mon, 14 Sep 2015 21:05:55 -0400 Subject: More JSON.mkd --- JSON.mkd | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) (limited to 'JSON.mkd') diff --git a/JSON.mkd b/JSON.mkd index e7bea7f8..72860cb3 100644 --- a/JSON.mkd +++ b/JSON.mkd @@ -368,7 +368,7 @@ the "Signals Defined from Diagnostic Messages" section below. **Response** -f the predefined requests were enabled or disabled successfully, the `status` in +If the predefined requests were enabled or disabled successfully, the `status` in the response will be `true`. { "command_response": "predefined_obd2", "status": true} @@ -377,7 +377,7 @@ the response will be `true`. The ModemConfigurationCommand message allows users to change certain aspects of modem operation on-the-fly (at runtime). The modem configuration settings are stored in flash memory and are untouched by the bootloader during a software update (assuming the correct cellular_c5 linker file is used during compilation of vi-firmware). Thus, new modem settings persistent across power cycles. -The ModemConfigurationCommand message provides three sub-messages for particular groups of modem settings. These are NetworkOperatorSettings, NetworkDataSettings, and ServerConnectSettings. These configuration messages are described in great detail within the cellular_c5_config documentation. +The ModemConfigurationCommand message provides three sub-messages for particular groups of modem settings. These are NetworkOperatorSettings, NetworkDataSettings, and ServerConnectSettings. These configuration messages are described in great detail within the [cellular_c5_config](vi-firmware/docs/advanced/cellular_c5_config.mkd) documentation. Currently, only the ServerConnectSettings sub-message is supported in the vi-firmware's command interpreter. All other settings are currently compile-time only. -- cgit 1.2.3-korg