summaryrefslogtreecommitdiffstats
path: root/meta-rcar-gen3-adas/recipes-kernel/linux
AgeCommit message (Collapse)AuthorFilesLines
2017-08-15revert gpio-max732x-set-gpio-ouput-low-at-initVladimir Barinov1-1/+0
This patch introduces bug
2017-08-15r8a7797: add V3MSK board, correct V3M Eagle dtsVladimir Barinov2-81/+326
2017-08-14r8a7797: fix csi2 node nameVladimir Barinov1-1/+1
2017-08-14Eagle r8a7797 support, adv7511 clock rate fixesVladimir Barinov3-194/+1002
1) support Eagle r8a7797 2) propagate max clock rate set for adv7511 via dts: Eagle and Kingfisher use ADV7511 KF rate 100Mhz Eagle rate 166Mhz
2017-08-11Gen3: disable autosuspend for SMSC usb hubsVladimir Barinov2-0/+52
Thisis a workaround for R-Car Gen3 XHCI
2017-08-10Kingfisher: enable PCM audio between CPU and BT moduleAndrey Gusakov4-14/+234
Add dummy driver for wl18xx PCM. Update dtb's. Update pulseaudio config. Also add ofono-test.
2017-08-10KF: fix DU RGB flickering, remove SDR50/104Vladimir Barinov5-3/+200
1) fix DU RGB port flickeringby presclaing clock in VC5 2) limit clock for DU RGB in driver adv7511 to 100Mhz this is according to Gen3 manual limitation for this DU port 3) update README 4) remove SDR50/104 from onboard KF
2017-08-09Sound: ak4613: suppress warning during pulseaudio probeAndrey Gusakov2-0/+61
2017-08-09KF: ADV7511 edid fixes, i2c2 speed 400khz, hsusb ws2.0 enableVladimir Barinov3-20/+82
1) fix edid get via adv7511 2) increase i2c2 speed from 100 to 400khz sine #1 fixed 3) enable hsusb for H3 ws2.0
2017-08-07KF: Add SDR50/104 for SDHI3Vladimir Barinov1-1/+3
SDR50/104 needs to set explicitly.
2017-08-06LVDS: workaroundpatch is not needed anymoreVladimir Barinov2-29/+0
optional compilation for Cogent firmware is not needed anymore since driver supports both firmware: Cogent and Vendor
2017-08-06Gen3: LVDS: fix RDCAM21/24 firmwareVladimir Barinov1-1/+7
1) This fixes/allows to use both Cogent and vendor firmware 2) this fixes dark envionment show: only for vendor f/w since EMB line is enabled but not showed in frame. Sensor EMB line is used in ISP.
2017-08-02Kingfisher: BT: use proper way to get shutdown gpioAndrey Gusakov3-9/+71
2017-08-02ADAS boards: fix ssi012(3)9 pinmuxex on H3 and M3Andrey Gusakov1-3/+3
H3 has ssi01239_ctrl group M3 has ssi0129_ctrl group
2017-08-01Kingfisher: fixes for bluetooth audioAndrey Gusakov1-0/+3
2017-08-01Fix build error: kf-v1 does not present anymoreVladimir Barinov1-3/+0
2017-07-31VIN: fix S_SELECTION (S_CROP IOCTL)Vladimir Barinov2-0/+68
2017-07-29ADAS boards: separate V0/V1 and V3 (default) KF boardsVladimir Barinov1-1438/+6627
2017-07-29LVDS cameras: fix typoVladimir Barinov1-2/+2
2017-07-28Kingfisher: BT: fix RTS/CTS and firmware pathAndrey Gusakov1-8/+8
2017-07-28Kingfisher V3: update m-channel sound support (fix)Andrey Gusakov1-1/+0
2017-07-28Kingfisher V3: update m-channel sound supportAndrey Gusakov3-315/+45
On V3 m-channel codec is moved to SSI34, so only minor update of sound driver is necessary.
2017-07-27LVDS: optional compilation for Cogent firmwareVladimir Barinov3-22/+130
This allows to use Cogent generated frimware for LVDS cameras (ov490+0v10640).
2017-07-27Kingfisher V3 updateVladimir Barinov2-0/+108
- correct SDHI3 for uhs mode enabled - add regulators to pcie-rcar - enable rpi camera
2017-07-27TTA-RDRIVE: remove unused patchVladimir Barinov1-1314/+0
2017-07-15lvds/VB/KF, cma memoryVladimir Barinov5-67/+271
- KF: set max9286 i2c address to 0x2c - disable eMMC on r8a7795-es1 - max7325: initialize pins to output-low - enlarge cma memory region on ulcb
2017-07-14Kingfisher: Fix BT speedVladimir Barinov3-21/+5
- enable SCI DMA in kernel config - Kingfisher: enable 3,3M baud rate
2017-07-14ov490 switch to vendor's firmware, OV495 OTP IDVladimir Barinov1-87/+76
1) This adds default RDCAM21/RDCAM24 firmware: /usr/share/factory/rcarm21.rdcam24.1280x1080@30.bin If firmware flashed with Cogent samples then it is possible to rollback using script: /usr/share/factory/rdcam21.rdcam24.1280x1080@30.bin ov495: change YUYV -> UYVY ti964/ti954: use FSIN reference clock from camera port0 2) Add ov495 OTP ID
2017-07-14add ov5642, fix DVP in VINVladimir Barinov6-20/+2426
- add ov5642 driver - fix parallel interfacein VIN - enable CMOS cameras on Kingfisher
2017-07-14Add EDT FT5X06 driverVladimir Barinov1-0/+1
2017-07-14KF: enable SAMVladimir Barinov1-3/+39
This enables iPod Authentication chip
2017-07-14KF: fix high rate renedering on adv7511Vladimir Barinov2-0/+27
LVDS DU does not support high freq
2017-07-14KF: ADV7511 EDID read workaroundVladimir Barinov1-3/+3
At 400kHZ the EDID may be read with error
2017-07-14ti9x4: fix FSINVladimir Barinov1-6/+6
2017-07-14Kingfisher: SSI, IIO updateVladimir Barinov1-73/+37
- change differnet sensor driver - share ssi8
2017-07-14Pack patches: put all ADAS boards patches on oneVladimir Barinov16-13993/+13643
2017-07-13Kingfisher: add multichannel audio, IMU driverVladimir Barinov6-26/+1789
- Fix multichannel in rcar sound (optional compilation) - add IMU driver - enable new sensor drivers - enalbe v3 usb3.0 firmware - deploy Videobox dtb files
2017-07-13add H3 Videobox boardVladimir Barinov2-0/+4141
2017-07-10I2C switch: fix PCA954x i2c expander accessVladimir Barinov2-0/+52
2017-07-05HAD: add missed serial alias for consoleVladimir Barinov2-2/+4
2017-06-04[kernel] Enable dummy interfaceGrigory Kletsko4-0/+4
2017-06-02Kingfisher: add ability to use SD on SDHI3Vladimir Barinov3-21/+93
2017-06-01Kinfgisher: add USB modem, RaspberryPi cameraVladimir Barinov7-22/+1212
2017-05-30Kingfisher V1 updateVladimir Barinov10-51/+1132
2017-05-25KF V1 deploy dtb imagesVladimir Barinov1-0/+3
2017-05-25Add CAN/CANFD/XHCI, fix build for CANFDVladimir Barinov7-24/+179
2017-05-24Fix build after adding KF V1Vladimir Barinov5-5/+5
2017-05-24Kingfisher M3: fix typoVladimir Barinov1-7/+1
2017-05-24LVDS cameras enumeration fixVladimir Barinov1-4/+4
GPIO needs to be released by deserializer
2017-05-24Add KF V1 boardVladimir Barinov5-402/+868