Initial version of Steering Wheel Microcontroller Firmwaresandbox/jsmoeller/WIP

Reads all buttons and sends out CAN bus messages similar to the
previous LIN converter.

Best use thonny as IDE/Editor. Board is available on ttyACM0.
Source code is stored on the board itself as:
- boot.py (blinks board at boot)
- main.py (main script that runs by default)

The steering wheel decoder is in the steering-wheel subfolder.
The monitor folder contains a simple serial monitor printing the CAN message.

You need a CANpico board for this.

The firmware used/tested with this code is in the firmware-CANpico subfolder.

Signed-off-by: Jan-Simon Moeller <jsmoeller@linuxfoundation.org>
Change-Id: I9751b6e0e7a2fc6cb6c82bb0a64719c6aa6ebe11

1 files changed, 23 insertions, 0 deletions

diff --git a/LICENSE b/LICENSE
new file mode 100644
index 0000000..09d59dc
--- /dev/null
+++ b/LICENSE
@@ -0,0 +1,23 @@
+Unless otherwise stated in the (sub-)folder or file, this software 
+is under the Apache-2.0 license.
+
+The shorthand used in the files is:
+
+SPDX-License-Identifier: Apache-2.0
+
+
+The license statement is below:
+
+Copyright 2022 The Linux Foundation
+
+Licensed under the Apache License, Version 2.0 (the "License");
+you may not use this file except in compliance with the License.
+You may obtain a copy of the License at
+
+http://www.apache.org/licenses/LICENSE-2.0
+
+Unless required by applicable law or agreed to in writing, software
+distributed under the License is distributed on an "AS IS" BASIS,
+WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+See the License for the specific language governing permissions and
+limitations under the License.
\ No newline at end of file