blob: a9f69be8bd5b231efeb475bd3bd957b86a22794f (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
|
From 9995ac251006b1ca4989c009129e13ecac8b3e50 Mon Sep 17 00:00:00 2001
From: Vladimir Barinov <vladimir.barinov@cogentembedded.com>
Date: Sun, 29 May 2016 23:18:49 +0300
Subject: [PATCH 003/122] spi: spi-gpio: fix CPOL mode
This fixes the SPI SPOL mode, since the cs_gpios is already used
in generic code spi.c
Signed-off-by: Vladimir Barinov <vladimir.barinov@cogentembedded.com>
---
drivers/spi/spi-gpio.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/spi/spi-gpio.c b/drivers/spi/spi-gpio.c
index 1c34c93..6e60521 100644
--- a/drivers/spi/spi-gpio.c
+++ b/drivers/spi/spi-gpio.c
@@ -218,10 +218,6 @@ static void spi_gpio_chipselect(struct spi_device *spi, int is_active)
struct spi_gpio *spi_gpio = spi_to_spi_gpio(spi);
unsigned long cs = spi_gpio->cs_gpios[spi->chip_select];
- /* set initial clock polarity */
- if (is_active)
- setsck(spi, spi->mode & SPI_CPOL);
-
if (cs != SPI_GPIO_NO_CHIPSELECT) {
/* SPI is normally active-low */
gpio_set_value_cansleep(cs, (spi->mode & SPI_CS_HIGH) ? is_active : !is_active);
@@ -257,6 +253,10 @@ static int spi_gpio_setup(struct spi_device *spi)
!(spi->mode & SPI_CS_HIGH));
}
}
+
+ /* set initial clock polarity */
+ setsck(spi, spi->mode & SPI_CPOL);
+
if (!status) {
/* in case it was initialized from static board data */
spi_gpio->cs_gpios[spi->chip_select] = cs;
--
2.7.4
|
